How to Install Shiplap


If you are planning to build a new home, there are several ways you can install shiplap. Some of the things you should consider when installing shiplap include the following:

Stagger the boards

Staggering the boards when installing shiplap can add visual interest. It also allows you to spread the joints out for improved stability. In addition, using this technique will help you avoid the need for too many screws.

When staggering, make sure you use the correct type of wood. This will ensure that you get a smooth and even finish. Also, ensure that the boards are treated to prevent moisture from warping the grain.

Before beginning installation, make sure that you have a level. A level will help you measure the correct widths. You can also use a stud finder to determine where the studs are in the wall. Once you’ve figured out where the studs are, you can begin nailing into them.

Using a pneumatic nail gun, you should have an air compressor available. Compressed air can help speed up the process.

Prime/paint the board

Painting the board before installing the shiplap will not only ensure a smooth installation but will also provide a uniform color application. If you are not very handy with paint, you can hire a contractor to do the job for you. This will save you both time and money. But painting your shiplap can be a breeze if you have some DIY skills.

First, you’ll need to determine the width of the boards. This is important because you will be installing them on a wall. Once you have your measurements, you can calculate the paint you need. Depending on the quality of the color you choose, you may want to use multiple coats.

You’ll want to use a relatively dry brush for the first coat. After that, you can use a one or 1.5-inch brush or a roller. Using a roller will help you apply the paint evenly.

Check every few boards to make sure the shiplap is level

If you’re planning to install shiplap in your home, you need to know how to check every few boards to ensure they’re level. This will help you avoid gaps in your board that will be difficult to fill. You can use a pocket square or a level to find the proper level.

The first step to shiplap installation is to measure the length and width of the walls. Next, find out the number of studs in each division. With a stud finder, you can quickly locate the studs. Once you’ve found them, it’s time to nail the board.

Start at the bottom of the wall and work your way up. If you’re working on a single accent wall, starting in the corner is a good idea. However, consider starting from the top if you’re working on a room with multiple divisions.

Place the boards in the most symmetrical or aesthetically pleasing configuration.

There are many ways to place shiplap boards, but if you want to get the most out of your effort, follow a few simple rules. For example, if you are installing the boards on a ceiling, you will need to calculate the best way to position them.

The first step is to calculate how much board you will need. This will be a function of the length of the wall. You will also need to determine how many rows you need. To make things easier, you can start by measuring the studs on your wall. If you can, try to find the studs at a stud finder.

Next, you will need to find the smallest possible gap between boards. Typically, a gap of about a quarter inch will do.

Calculate the placement of boards across your wall/ceiling

When you decide to install shiplap, there are a few things you need to keep in mind. The first thing to do is calculate how many rows of boards you’ll need to cover the wall. You can do this by dividing the length of the wall by the height.

Next, you’ll need to determine the spacing between the boards. Typically, you’ll want to use as little board as possible per row. However, if may want to start in the corner if you have multiple walls.

Once you’ve determined the spacing between the boards, you’ll need to mark out the planks. Usually, the rough edges on a shiplap board are on the sides. To do this, draw a line with a pencil on each plank.

Once you’ve marked out each board, you’ll need to cut the edges. Again, a jigsaw works well for this. Alternatively, you can use a circular saw.